ASTM 255
2014-09-28 11:43:18 Origin： Remark：0 Click：
Description ASTM 255 datasheet, AISI 255 Chemical, ASTM 255 Properties Steelmaking,Blooming, Hot forging, Hot rolling, Heat treatment, Straightening, 100% Ultrasonic flaw detection test, Cold working or Machined. All of these materials conform to Military standard, nuclear power. 100% Ultrasonic test ASTM E2375 /SAE AMS 2154 /SEP 1923 /GB/T 4162 /EN 10228-3.
DUPLEX STAINLESS STEEL DATA SHEET - ASTM 255
OFFICIAL TEST CERTIFICATE: issued by TUV - SGS - BV
MATERIAL CATEGORY: 25Cr - 6Ni - 3Mo - 2Cu stainless
CHEMICAL COMPOSITION (WEIGHT %)
C (％): ≤ 0.040
Si (％): ≤ 1.00
Mn (％): ≤ 1.50
P (％)≤: 0.040
S (％)≤: 0.030
Cr (％): 24.0 ~ 27.0
Ni (％): 4.50 ~ 6.50
Mo (％): 2.90 ~ 3.90
Si (％): ≤ 1.00
Mn (％): ≤ 1.50
P (％)≤: 0.040
S (％)≤: 0.030
Cr (％): 24.0 ~ 27.0
Ni (％): 4.50 ~ 6.50
Mo (％): 2.90 ~ 3.90
Cu (%): 1.50 ~ 2.50
N (%): 0.10 ~ 0.25
MECHANICAL PROPERTIES UNDER ROOM TEMP.
Tensile strength, σb/≥ MPa: 700
Yield strength, σ0.2/MPa: 530
Elongation, δ ≥(％): 20.0
Reduction of area, ф ≥ (％): -
Hardness via heat treatment /HBW: 290
Reduction of area, ф ≥ (％): -
Hardness via heat treatment /HBW: 290
PRODUCT DESCRIPTION
The alloy is usually produced by AOD / VD / VIM followed by electroslag refining (ESR) / VAR if necessary for special purpose.
Bars and, where applicable, forgings are subjected to ultrasonic examination based on the different levels according to the buyers' requirements.
Bars are usually supplied black/bright in the softened condition.
Final heat treatment - solution treatment / QT.
TYPICAL APPLICATIONS
Chemical equipment
Mechanical parts used in the condition of corrosion resistance
Bolt and nut
Pressure vessel
AVAILABLE FORMS AND SHAPES
Round bar (Diameter): 5.5 ~ 550mm
Square bar / Flat bar: 3 ~ 350mm
AVAILABLE FORMS AND SHAPES
Round bar (Diameter): 5.5 ~ 550mm
Square bar / Flat bar: 3 ~ 350mm
Wire rod (Diameter): 0.10 ~ 16mm
Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form).
Forging piece: Different shapes based on OEM.
Steel strip via cold rolled: T0.1 - 3mm X W5 - 650mm X L (or in coil form).
Forging piece: Different shapes based on OEM.
Other sizes can be supplied to meet specific requirements.
TECHNICAL SALES ASSISTANCE
If you meet further on any technical enquiry, pleased to EMAIL (sales@ccsteels.com) our qualified production engineers.
If you meet further on any technical enquiry, pleased to EMAIL (sales@ccsteels.com) our qualified production engineers.
